LVC07A HEX Buffers/drivers WITH Open-drain Outputs. FEATURES. Operate From 5 V Inputs and Open-Drain Outputs Accept Voltages V. These hex. LVC07A Datasheet, LVC07A PDF, LVC07A Data sheet, LVC07A manual, LVC07A pdf, LVC07A, datenblatt, Electronics LVC07A, alldatasheet, free, datasheet. LVC07A datasheet, LVC07A circuit, LVC07A data sheet: TI – HEX BUFFERS DRIVERS WITH OPEN-DRAIN OUTPUTS,alldatasheet, datasheet, Datasheet.
|Country:||Saint Kitts and Nevis|
|Published (Last):||1 November 2010|
|PDF File Size:||12.32 Mb|
|ePub File Size:||16.85 Mb|
|Price:||Free* [*Free Regsitration Required]|
At first glance, the current should always be well below the 50mA max output current spec, so I would expect this configuration to be fine. I sent this question to NXP tech support 3 days ago, and haven’t heard from them yet.
Maybe someone on this forum can give me a definitive answer so I can proceed datawheet the design. You’re kind of in a gray area.
The output should not break down until you get to more than 6.
Remember that “limiting values” aka “absolute maximum” are not intended to indicate where the part should be operated continuously for reliable operation. The recommended maximum output voltage for normal operation is less than 5. Ignore that at your peril- only you know what the consequences of a failure are. It’s also better to drive the inputs right to the rails otherwise the current draw of the could go up. That’s what I suggest doing. This was the response:. Using the 74LVC07A is one of the more common ways to interface 3.
The note in the LVC07A datasheet “The output voltage ratings may be exceeded if the output current ratings are observed” allows you to let the output be pulled higher than the suggested limit of 6.
LVC07A 데이터시트(PDF) – TI store
Datahseet uA should be no issue in fact, you may want to reduce that 10K resistor if you need to improve the rise time of the output signal. I find it interesting that he refers to the Absolute Maximum Rating as a “suggested limit. Since this answer comes from the device manufacturer, I will mark it as being the correct answer.
Spehro Pefhany k 4 Thank you Spehro, this is an excellent and thorough answer, and you provided an alternative solution that is elegant and economical. Since I eventually received a reply to my inquiry from NXP Support, and they responded that my original approach was permissible, I have posted their response and I expect to mark it as the correct answer. Good that you got something in writing.
I find “should be no issue” somewhat different from “is definitely no problem” though. This was the response: Your uA should be no issue in fact, you may want to reduce that 10K resistor if you need to improve the rise time of the output signal Regards Tom Logic Applications Engineering I find it interesting that he refers to the Absolute Maximum Rating as a “suggested limit. Sign up or log in Sign up using Google. Sign up using Facebook. Sign up using Email and Password.